Modified Front Hubs

After the bush upgrade, next was adding longer studs to the front hubs for the 10mm spacers. This is one of the changes that I am not convinced will beneft to much but I will do it anyway. Two sets of M12 x 1.5 x 63mm studs and some 10mm spacers ordered I take two spare hubs apart. While they are apart its best to replace the wheel bearings so these are pressed in.

Realising to press the studs in I need to drill the holes in the hub out to 12.5mm I order a hardened drill bit that lasts two seconds in Dad’s pillar drill at the first attempt. This puts the process on hold until I can visit an engineering shop and get them machined out rather than eat drills!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s