Fire Extinguisher – Fit

Now I was a bit apprehensive about this, not something I have done before – a minimum 4L Mechanical or Electrical plumbed in Fire Extinguisher is required. I purchased a Mechanical Sparco 4.25 Litre Plumbed in kit from Demon Tweeks. In fact the instructions were very good, the kit push fit with pliable tube was easy to put together – the thought was just how best to run it through the car. The instructions state the each foot well pointing to the drive/passenger abdomen and four corners on the engine bay. Once run through using existing grommet holes in the bulkhead and the red sleeve put on the tubing then it actually was a bit of time but not difficult.

I have ordered some P clips to neaten up the retention of the pipe and nozzles, but another job done.





Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s